Terminology | 43Greensource CDi Series TW Model
8733954853 (2020/04)Greensource CDi Series TW Model
Subject to change without prior notice
TERMINOLOGY
Acronyms
COP — Coefficient of Performance. The COP provides a
measure of performance for heat pumps that is
analogous to thermal efficiency for power cycles.
ECM — Electronically Commutated Motor
EER — Energy Efficiency Ratio
FLA — Full Load Amps
GLHP — Ground Loop Heat Pump
HP — Heat Pump
HPS — High-Pressure Switch
IOM — Installation, Operation, and Maintenance Manual
LED — Light Emitting Diode
LPS — Low-Pressure Switch
LRA— Locked Rotor Amps
NPA — Name Plate Amps
PSC — Permanent-Split Capacitor Motor
(R/A) — Return Air
RLA — Running Load Amps
UPM — Unit Protection Module
WLHP — Water Loop Heat Pump
Terms
Conditioned space — Space within a building provided
with heated or cooled air or both (or surfaces) and,
where required, with humidification or dehumidification
means to maintain conditions for an acceptable thermal
environment.
Decommissioning — Means the final shut-down and
removal from operation or usage of a product or piece
of equipment containing fluorinated greenhouse gases.
Discharge Pressure — Referring to the pressure leaving
compressor.
Reclamation — Means the reprocessing of a recovered
fluorinated greenhouse gas in order to match the
equivalent performance of a virgin substance, taking
into account its intended use.
Recovery — Referring to the collection and storage of
fluorinated-greenhouse gases from products (including
containers and equipment) during maintenance or
servicing or prior to the disposal of the products or
equipment.
Recycling — Referring to the reuse of a recovered
fluorinated-greenhouse gas following a basic cleaning
process.
Repair — Referring to the restoration of damaged or
leaking products or equipment that contain, or whose
functioning relies upon, fluorinated-greenhouse gases,
involving a part containing or designed to contain such
gases.
Suction Pressure — Referring to the pressure entering
compressor.
To Next Page