Bosch Kiox BUI330 - Operation and Initial Setup; Initial Commissioning and Basic Settings

English – 13
Kiox holder can be swivelled sideways. Put the on-board computer in the
holder. Screw the locking screw (M3 thread, 6mm long) from below into the
thread provided in the on-board computer (using a longer screw may dam-
age the on-board computer). Swivel the holder back into place and tighten
the headset screw in accordance with the manufacturer's specifications.
Operation
Before initial commissioning
The Kiox is supplied with a partially charged battery. Before using it for the
first time, this battery must be charged for at least one hour via the USB port
(see "Power supply of the on-board computer", pageEnglish – 15) or via
the eBike system.
The control unit should be attached such that the buttons are almost per-
pendicular to the handlebars.
When using the on-board computer for the first time, the language selection
page is displayed initially. You can then choose to have essential functions
and indications explained via the <Intro to Kiox> menu item. The menu item
can also be called up at a later time via <Settings>→ <Information>.
Switching the on-board computer on/off
To switch on and switch off the on-board computer, briefly press the on/off
button(4).
Selecting system settings
Fit the on-board computer in the holder and proceed as follows while the bi-
cycle is stationary:
Go to the status page (use the <button(10) on the operating unit to get to
the first display) and press the select button(9) to call up the <Settings>.
You can use the –(11) and +(12) buttons to select the setting you want.
You can open the settings, as well as any additional submenus, using the se-
lect button(9). You can use the <button(10) to go back to the previous
menu from any settings menu.
Bosch eBike Systems 1 270 020 Ken | (25.08.2020)