Bosch Kiox BUI330 - Using the Push Assistance Function

English – 18
Note: In some models, the assistance level may be preset and cannot be
changed. There may also be fewer assistance levels available than stated
here.
The following assistance levels are available as a maximum:
– OFF: Motor assistance is switched off. The eBike can just be moved by
pedalling, as with a normal bicycle. The push assistance cannot be activ-
ated at this assistance level.
– ECO: Effective assistance with maximum efficiency, for maximum range
– TOUR: Steady assistance, long range for touring
– SPORT/eMTB:
SPORT: Powerful assistance, for mountain biking and cycling in urban
traffic
eMTB: Optimum assistance whatever the terrain, rapid acceleration
when starting from a standstill, improved dynamics and top performance
(eMTB only available in combination with the drive units BDU250P CX,
BDU365, BDU450 CX and BDU480 CX. A software update may be re-
quired.)
– TURBO: Maximum assistance even at high pedalling speeds, for sport
cycling
To increase the assistance level, press the + (12) button on the operating
unit repeatedly until the desired assistance level appears on the display. To
decrease the assistance level, press the – (11) button.
The requested motor output appears on the displayh (see "Start page",
pageEnglish – 27). The maximum motor output depends on the selected
assistance level.
If the on-board computer is removed from the holder(5), the assistance
level that was last displayed is saved.
Switching the push assistance on/off
The push assistance aids you when pushing your eBike. The speed in this
function depends on the selected gear and can reach a maximum of 6km/h.
The lower the selected gear, the lower the speed of the push assistance
function (at full power).
u The push assistance function must only be used when pushing the
eBike. There is a risk of injury if the wheels of the eBike are not in contact
with the ground while using the push assistance.
Bosch eBike Systems 1 270 020 Ken | (25.08.2020)