Bosch MUM 2 Series - Tools; Parked position; Cable length; Using the cord storage

en Operation
20
Tools
Tool Use
Kneading hook
¡ Knead dough, e.g. yeast
dough, bread dough, pizza
dough, pasta dough, pastry
dough.
¡ Fold ingredients into the
dough, e.g. seeds.
Stirring whisk
¡ Mix dough, e.g. cake mix-
ture, fruit flan.
¡ Fold ingredients into the
dough, e.g. raisins, chocol-
ate chips.
Beating whisk
¡ Beat whipped egg whites
and cream (at least 30%
fat).
¡ Mix light dough, e.g.
sponge mixture.
Parked position
After the appliance has switched off, the
drives will continue moving for a few
seconds until the correct parked position is
reached.
Note:The swivel arm will only open or close
with the inserted tool when the drive is loc-
ated in the correct parked position.
Tip:You can easily adjust an incorrect
parking position yourself.
→"Troubleshooting", Page22
Cable length
Using the cord storage
1. Pull the power cable out to the required
length.
2. To shorten the cable, push it into the
cable storage compartment.
Safety systems
Start lock-out
Start lock-out prevents your appliance from
being switched on accidentally.
The appliance can only be switched on and
operated if the swivel arm is correctly en-
gaged in the work position.
Restart lock-out
Restart lock-out prevents your appliance
from automatically restarting processing
after a power failure.
The appliance is switched on again after a
power failure. Processing cannot start
again until the rotary switch has been set to
⁠.
Overload protection
The overload protection system prevents
the motor and other components from be-
ing damaged through being overloaded.
Operation
Operation
Operation
Preparing the appliance
1. Place the appliance on a stable, level,
clean and flat work surface.
2. Press the release button and raise the
swivel arm until it engages.
→Fig. 3
3. Place the bowl in the main unit.
→Fig. 4
Use the recesses on the main unit.
4. Press the tool into the main drive until it
engages.
→Fig. 5
5. To insert the kneading hook:
‒ Insert the kneading hook with the pro-
tective cap fitted in the main drive.
‒ Turn the protective cap until the
kneading hook engages fully.
→Fig. 6
The protective cap must cover the
main drive completely.
6. Add the ingredients to the bowl.
→Fig. 7
7. Press the release button and push the
swivel arm down but not fully down.
→Fig. 8
Hold the swivel arm in a slightly open po-
sition.