Bosch MUM 2 Series - Processing ingredients with tools; Finishing processing; Using accessory drives; Overview of cleaning

Overview of cleaning en
21
8. Lift the lid slightly at the front, slide fully
onto the bowl and set down.
→Fig. 9
9. Push the swivel arm down until it en-
gages.
→Fig. 10
Processing ingredients with tools
1. Insert mains plug.
2. Set the rotary switch to the required
speed.
→Fig. 11
3. To process the ingredients at maximum
speed for a short time, set the rotary
switch to and hold for the desired pro-
cessing time.
→Fig. 12
4. If wished, further ingredients can be ad-
ded during processing using the filling
shaft.
→Fig. 13
5. To add greater quantities of ingredients:
‒ Turn the rotary switch to and
wait for the appliance to come to a
standstill.
‒ Lift the swivel arm slightly and pull out
the lid.
‒ Add the ingredients to the bowl.
‒ Fit the lid and push the swivel arm
down until it engages.
6. Process the ingredients until you achieve
the required result.
7.
Set the rotary switch to ⁠.
→Fig. 14
Wait until the appliance stops.
a Processing stops and the drives move to
the parked position.
Finishing processing
1. Unplug the mains plug.
2. Press the release button, raise the swivel
arm slightly and hold in place.
→Fig. 15
3. Lift the lid slightly at the front and pull it
out towards the front.
→Fig. 16
4. Push the swivel arm up until it engages.
→Fig. 17
5. Pull the tool completely out of the drive.
→Fig. 18
6. Lift and remove the bowl.
→Fig. 19
Using accessory drives
Notes
¡ Remove the cover to use accessories on
drive 2 or 3.
¡ Always close unused drives with the cov-
ers.
¡ Please follow the instructions for the ac-
cessory.
1. Lift the cover of drive 2 by the side open-
ing and remove.
→Fig. 20
2. Fit the cover of drive 2 and press down
firmly.
→Fig. 21
3. Pull up the protective cover for drive3
and remove.
→Fig. 22
4. Position the protective cover for the
drive3 and press in place firmly.
→Fig. 23
The and markings must match up.
Overview of cleaning
Overview of cleaning
Overview of cleaning
Clean the individual parts as indicated in
the table.
Clean all parts immediately after use so that
residues do not dry on.
→Fig. 24
▶ Do not use cleaning agents containing
alcohol or spirits.
▶ Do not use sharp, pointed or metal ob-
jects.
▶ Do not use abrasive cloths or cleaning
agents.
▶ Only clean the transparent bowl made of
Tritan with a detergent solution and a
soft cloth or sponge.