Bosch MUMS2EW01 - Removing Bowl Lid; Processing; Drive Cover

en operation
30
3. Push the swivel arm down until it
engages.
→Fig.
12
7.8 Removing bowl lid
1. Press the release button, raise the
swivel arm slightly and hold in
place.
2. Lift the lid slightly at the front and
pull it out towards the front.
3. Push the swivel arm up until it en-
gages.
7.9 Processing
You can find out everything you need
to know about processing food here.
Recommended speeds
Observe the recommended speeds
for optimum results.
Setting Use
1-2 Stir in and mix ingredients.
1-2 Knead heavy dough, e.g.
yeast dough.
3-4 Beat and stir ingredients,
e.g. whipped cream.
Processing ingredients with tools
Requirements
¡ The bowl has been inserted.
¡ The required tool is inserted.
1. Add the ingredients to the bowl.
2. Press the release button and push
the swivel arm down until it en-
gages.
3. Insert mains plug.
4. Set the rotary switch to the re-
quired speed.
→Fig.
13
5. Process the ingredients until you
achieve the required result.
6. Set the rotary switch to
⁠.
→Fig.
14
Wait until the appliance stops.
7. Set the rotary switch to and hold.
→Fig.
15
a The drive slowly moves until the
correct parked position is reached.
8. Unplug the mains plug.
Tips
¡ You can change the speed at any
time during processing or interrupt
processing.
¡ Clean all parts immediately after
use so that residues do not dry on.
Adding more ingredients
1. To add ingredients during pro-
cessing, use the filling shaft in the
lid.
→Fig.
16
2. To add large quantities, set the
rotary switch to ⁠.
Wait until the appliance stops.
3. Set the rotary switch to and hold.
→Fig.
15
a The drive slowly moves until the
correct parked position is reached.
4. Remove the bowl lid.
→"Removing bowl lid", Page30
5. Add the ingredients to the bowl.
6. Attach the bowl lid.
→"Attaching bowl lid", Page29
7. Process the ingredients until you
achieve the required result.
7.10 Drive cover
Remove the protective cover to use
accessories on drive 2 or 3.
Removing drive cover
1. Lift the protective cover of drive 2
by the side lug and remove.
→Fig.
17