Bosch MUMS6EW22 - Basic Operation; Finishing Processing; Preparing the Appliance; Processing Ingredients with Tools

Basic operation en
33
Basic operation
7 Basic operation
Basic operation
7.1 Preparing the appliance
1. Press the release button and raise
the swivel arm until it engages.
→Fig. 6
2. Place the bowl in the main unit.
→Fig. 7
Use the recesses on the main unit.
3. Turn the bowl anticlockwise until it
engages.
→Fig. 8
4. Fit the lid onto the main drive until
it engages.
→Fig. 9
The filling shaft must face towards
the front.
5. Press the tool into the main drive
until it engages.
→Fig. 10
The protective cap must cover
the main drive completely.
6. Add the ingredients to the bowl.
→Fig. 11
7. Press the release button and push
the swivel arm down until it en-
gages.
→Fig. 12
7.2 Processing ingredients
with tools
1. Insert mains plug.
2. Set the rotary switch to the re-
quired speed.
→Fig. 13
3. If wished, further ingredients can
be added during processing using
the filling shaft.
→Fig. 14
To add greater quantities, switch
off the appliance, open the swivel
arm and transfer the ingredients to
the bowl.
4. Process the ingredients until you
achieve the required result.
5. Set the rotary switch to ⁠.
→Fig. 15
Wait until the appliance stops.
7.3 Using instantaneous
switching
1. Set the rotary switch to and
hold.
→Fig. 16
a The ingredients are processed at
maximum speed.
2. Release the rotary switch.
→Fig. 17
a The rotary switch springs to ⁠.
a Processing stops.
Tip:Instantaneous switching is espe-
cially suitable when using the glass
blender attachment.
7.4 Finishing processing
1. Unplug the mains plug.
→Fig. 18
2. Press the release button and raise
the swivel arm until it engages.
→Fig. 19
3. If the swivel arm does not open
easily or there is a lot of dough on
the tool, proceed as follows:
‒ Open up the swivel arm a bit
and use a spatula or wooden
spoon to push the dough off the
tool.