Troubleshooting en
37
Fault Cause and troubleshooting
The swivel arm cannot
be opened or closed
because the tool is
jammed in the bowl.
Drive is not in the parked position.
1. Set the rotary switch to .
2. When the swivel arm is open, remove the tool and
close the swivel arm.
3. Set the rotary switch briefly to and then back to .
a The drive remains on for a short time until the
parked position is reached.
The beating whisk
does not touch the
bowl or the ingredi-
ents are not mixed
properly.
The distance to the bowl is not set correctly.
▶ Correct the fine adjustment of the beating whisk.
→"Fine adjustment of beating whisk", Page31
To Next Page
Loading...
