Bosch NBE-5702-AL - Page 21

DINION 5100i IR Configuration | en 21
Bosch Security Systems B.V.
User manual
2023-08 | V01 | F.01U.393.997
– The Live Video window shows a live video stream. Click in the live video window to
move the device and center its field of view at the selected position. The device also
automatically levels the horizon.
– On some browsers, such as Firefox and Chrome, a rectangle can be drawn on the
live video window. The device automatically centers the field of view at the selected
position, levels the horizon and also zooms in.
– Set lens to default position
– Select Default to set the lens to its default position.
– Optical zoom
– Use the slider to adjust the optical zoom.
– Autofocus
– Select either Local Range (preferred selection) or Full Range (backup selection) to
automatically focus the image.
– Focus position
– Use the slider to adjust the focus position. The focus position automatically adjusts
to the autofocus.
– Focus indicator
– The Focus indicator shows a value related to the focus quality of the image. The
higher the value, the more in focus the image will be.
– Lens
– Indicates the lens type in use.
– IR-corrected lens
– Click the checkbox to activate or deactivate IR correction function.
The setting of the lens mode is crucial to ensure optimal performance. In daylight
operation, the IR-corrected mode is not required. In dark environments where the
majority of light is provided by the IR illuminators, the lens should be set to IR-
corrected mode. Otherwise, if sufficient ambient light is available, disable the IR-
corrected mode. An incorrect lens setting could result in improper focusing.
Camera LED
Click the Enabled or Disabled check-box to switch the Camera LED on or off.
Select Auto disable to let the camera determine when the LED should be switched off.
The camera LED activates when powering on the camera for the first time. The LED
deactivates automatically after 5min.
USB port
Select the corresponding radio button to enable or disable the USB port.
A tooltip message is displayed if no supported USB devices are detected when the USB port is
enabled.
Reboot device
Click the Reboot button to restart the device. The entire reboot sequence takes approximately
60seconds.
Restore settings
Click Restore to restore all settings, except network settings, to their defaults.
Note: Clicking this button also clears the service-level password. Operators must reset the
password before doing anything else.
Factory defaults
Click Defaults to restore all settings, including passwords and network settings, to their
defaults.