AUTODOME IP 4000i Installing an In-ceiling Camera in a Suspended Ceiling | en 23
Bosch Security Systems Installation Manual 2017.08 | 1.0 | F.01U.xxx.xxx
Warning!
Over torquing the ceiling clamps can damage the clamp or ceiling. Only tighten the clamp
until it contacts the ceiling and you start to feel some resistance. If using a power
screwdriver, set the torque level to the lowest setting.
5. Place the trim ring / bubble enclosure in position over the camera block, aligning the
three (3) screws. Tighten the screws firmly to secure the trim ring / bubble enclosure to
the in-ceiling bracket.
To Next Page
Loading...
