26 en | Installing an In-Ceiling Camera in a Drywall Ceiling AUTODOME IP 4000i
2017.08 | 1.0 | F.01U.xxx.xxx Installation Manual Bosch Security Systems
2. Insert the camera (without the trim ring / bubble enclosure) into the hole in the ceiling.
Ensure not to pinch the cables.
3. Turn each fastening screw to secure the clamps in the ceiling.
4. Tighten the clamps using the Phillips screwdriver to secure the housing to the ceiling.
Warning!
Over torquing the ceiling clamps can damage the clamp or ceiling. Only tighten the clamp
until it contacts the ceiling and you start to feel some resistance. If using a power
screwdriver, set the torque level to the lowest setting.
5. Place the trim ring / bubble enclosure in position over the camera block, aligning the
three (3) screws. Tighten the screws firmly to secure the trim ring / bubble enclosure to
the in-ceiling bracket.
To Next Page
Loading...
