Bosch PAVIRO PVA-2P500 User Manual

Configuration
Setting the CAN address
The CAN address of the device is set using the two address selector switches HIGH and LOW.
Addresses 1 to 250 (01 hex to FA hex) can be used in a CAN network. The address is set using
the hexadecimal numbering system. The LOW selector switch is for the low-order digit and the
HIGH selector switch is for the high-order digit.
Notice!
Each address may only occur once in the system, otherwise network conflicts will occur.
The address 0 (00 hex, set on delivery) ensures that the device is disconnected from the
remote communication. This means that the device does not appear in the system, even if it is
connected to the CAN bus.
HIGH LOW Address
0 0 Stand-alone
0 1 to F 1 to 15
1 0 to F 16 to 31
2 0 to F 32 to 47
3 0 to F 48 to 63
4 0 to F 64 to 79
5 0 to F 80 to 95
6 0 to F 96 to 111
7 0 to F 112 to 127
8 0 to F 128 to 143
9 0 to F 144 to 159
A 0 to F 160 to 175
B 0 to F 176 to 191
C 0 to F 192 to 207
D 0 to F 208 to 223
E 0 to F 224 to 239
7
7.1
PAVIRO Amplifier Configuration | en 23
Operation manual 18-Jun-2015 | 04 | F01U306898

Bosch PAVIRO PVA-2P500 Specifications

General

Amplifier class	D
Frequency range	50 - 25000 Hz
Audio output channels	- channels
Peak power per channel	500 W
Signal-to-Noise Ratio (SNR)	104 dB
Total Harmonic Distortion (THD)	1 %
Purpose	-
Grounding	Yes
Cooling type	Passive
Product color	Black
Connectivity technology	Wireless
Maximum current	2 A
AC input voltage	115 - 240 V
DC input voltage	21 - 32 V
Power protection features	Short circuit, Under voltage
Power consumption (standby)	3 W
Ethernet LAN (RJ-45) ports	2
Speakers connectivity type	RJ-45
Operating temperature (T-T)	-5 - 45 °C
Package weight	19000 g

Weight and Dimensions

Depth	88.2 mm
Width	483 mm
Height	391 mm
Weight	16500 g