Short information
The PVA-2P500 class-D amplifier is a 2 ✕ 500 W professional audio amplifier for evacuation
purposes. It can be operated from both the mains and a DC supply. The output voltage is
galvanically insulated and is constantly monitored for ground fault. An energy-saving mode and
temperature-controlled fans reduce energy consumption and noise levels. The control and
monitoring functions are performed via CAN bus. This amplifier is designed for operation in an
emergency evacuation system. It can be used as system amplifier or in stand-alone mode. The
amplifiers are usually controlled via a controller and configured using IRIS-Net.
The power amplifier has the following features:
– Floating 100 V or 70 V power outputs
– High efficient amplifier blocks in class-D technology
– Outputs idling and short circuit-protected
– Mains operation 120–240 V (50/60 Hz) and/or 24 V DC emergency backup
– Electronically balanced inputs
– Temperature monitoring function
– Pilot tone and ground fault monitoring function via PVA-4CR12 controller or PVA-4R24
router
– Processor control of all functions
– Monitoring of the processor system via watchdog circuit
– Non-volatile FLASH memory for configuration data
– Internal monitoring function
– Integrated audio relays
– Line monitoring function
The power amplifier is processor-controlled and equipped with extensive monitoring
functions. Line monitoring for the CAN bus and for audio transmission allows line
interruptions and short-circuits to be detected and indicated to the user.
2
8 en | Short information PAVIRO Amplifier
18-Jun-2015 | 04 | F01U306898 Operation manual
To Next Page
Loading...
