Professional Series TriTech AM Motion Detectors
with Anti-mask, LSN
Installation | en 13
Bosch Building Technologies Reference Manual 2018.10 | 01 | F.01U.352.414
Notice!
Do not use the bracket to tip the detector vertically unless you intend to compensate for a
non-vertical surface. It might cause false alarms or reduced catch performance.
5.3 Wire knockouts
Use the figure to determine the knockouts to use for installation locations.
Callout ᅳ Description
1 ᅳ Surface wiring knockout, detector’s left side
2 ᅳ Through-the-wall wiring knockout
3 ᅳ Surface wiring knockout, detector’s right side
4 ᅳ Through-B328-bracket wiring knockout*
* If you use the bracket mount knockout for wires, run the wires between the walls marked
in red in the figure. With the wiring between the walls and behind the terminal block, other
features, such as EOL resistor jumper pins, cannot interfere with or puncture the wires.
To Next Page
Loading...
