14
Remote control
6 720 606 990
control (Fig. 12, pos. 3) for 3
seconds.
Fig. 12 Memorizing water
temperature
B Only one temperature per remote
control can be memorized using the
"Program" button on the remote
control.
B At this point the remote control will
display the memorized temperature .
When the hot water tap is turned on,
the water heater will supply hot
water at the temperature memorized
on the remote control.
Using the "Program" button
(operation with memorized
temperature)
To operate the equipment with a
previously memorized temperature:
B Press the "Program" button on the
remote control.
The remote control display and heater
display will now show the previously
memorized temperature. When the hot
water tap is turned on, the water heater
will supply hot water after a few
seconds, at the memorized
temperature.
i
Note: Previously saved
temperature may show
on the display when first
pushing the program
button. Once "PR"
shows on the display,
the desired setting will
be saved.
i
Up to six addition remote
controls can be used to
memorize a temperature
for each remote control.
6720606990-0701_(Remote control)16Nov.fm Page 14 Friday, November 16, 2007 3:04 PM
To Next Page
Loading...
Need help?
General
