Need help?Do you have a question about the Bosch Rexroth CS 106 and is the answer not in the manual?
General| Brand | Bosch |
|---|---|
| Model | Rexroth CS 106 |
| Category | Controller |
| Language | English |
Powers up the unit's proportional electronics, separate from auxiliary switches.
Provide precision control signals for proportional feathering to valve drivers.
Configurable to activate multiple functions simultaneously when momentarily pressed.
Visually indicates programming and fault conditions through diagnostic flashes.
Sets the unit into program mode for configuration and adjustments.
Used in program mode to set minimum and maximum operational range.
Resets trim values to minimum (800mA) and maximum (1800mA) factory settings.
Indicates controller supply voltage is below 10v with a specific beep and flash pattern.
Interprets channel-specific faults via two sets of red flashes separated by a green flash.
Detects a defective trim switch faulted in the minimum or maximum position.
Detects a defective Park button that is faulted in the 'on' position.
Indicates if minimum trim value is set higher than the maximum trim value.
Procedure to disable or enable the diagnostic buzzer alert in operation mode.
Details on utilizing a RAM ball for mechanical mounting.
Details on utilizing a pedestal tube for mechanical mounting.
Details on utilizing an armrest for mechanical mounting.
To Next Page