Bosch Rexroth CS 106 - Layout Overview; Panel Controls and Functions; Power Switch Operation; Paddle and Joystick Actuators

2
1 LAYOUT
The CS 106 is a customized proportional controller utilizing single axis paddles or 1 to 3 axis
joysticks. All outputs can have minimum and maximum trim values to provide precise hydraulic
control. Configurable Park set points allow multiple outputs to be activated at the same time to
provide an emergency raise or convenient stow option. Shrouds and output interlocks are
available to comply with safety standards. The controller has on-board diagnostics to indicate
fault conditions and to localize the problem. Custom auxiliary rocker switches are also available.
2 PANEL CONTROLS
Power switch – Powers up the
proportional electronics (Aux switches
are powered separately)
Diagnostic Indicator – Visually indicates
programming and fault conditions through a
series of diagnostic flashes. An internal
buzzer is also included to communicate
status and faults.
Paddle / Joystick – Sends a precision
signal to the valve drivers to allow
proportional feathering.
Program Key Switch – Sets the unit into
program mode.
Min / Max Trim Switch – used in program
mode to set the minimum and maximum
operational range of Paddle / Joystick
Function.
Park button – Can be configured to
activate multiple functions
simultaneously when the switch is
momentarily pushed
Proportional Joystick /
Paddle Actuators
Park
(emergency)
Button
Diagnostic
Indicator
Program
Key switch
Min/Max
Trim switch
Power
Switch
Auxiliary function
rocker switches
Deadman Interlock
button (Required as per
local regulations)