Assembly 59/128
CytroBox, RE 51057-B/11.19, Bosch Rexroth AG
7 Assembly
7.1 Unpacking the hydraulic power unit
Before opening the packaging and/or loosening the tension belts, make sure that
the hydraulic power unit cannot fall over.
Remove the packaging of the hydraulic power unit.
Check the hydraulic power unit for obvious defects, for example transport
damage, leakage or other external damage, and for completeness,
seechapter4"Scope of delivery".
Use the hydraulic power unit only in technically perfect condition.
Dispose of the packaging material in accordance with the national regulations
in your country and/or your company-internal specifications/procedures.
7.2 Installing the hydraulic power unit
WARNING
Falling, tumbling or uncontrolled position change of the hydraulic power unit!
Risk of injury! Damage to property!
Make sure that the hydraulic power unit is only installed and assembled by
qualified personnel. See chapter2.4 "Qualification of personnel".
Observe the information on handling the product in chapter 6
"Transport and storage".
Position the hydraulic power unit on a suitable foundation.
Observe the specifications on the total weight.
NOTICE
Damage to the surface/oil tank due to rough handling and incorrect positioning!
Damage to property!
Make sure that the hydraulic power unit is correctly positioned.
Vibrations in the environment!
Damage to property!
Connect the hydraulic power unit to the machine via hydraulic hoses.
Do not use any rigid pipelines.
To install the hydraulic power unit, you should proceed as follows:
Put the hydraulic power unit on a level ground.
Level the hydraulic power unit using the adjustable machine feet so that its
longitudinal and transverse axis are horizontal.
To Next Page
Loading...