Bosch rexroth CytroBox - 10.2 Inspection; 10.3 Warning devices

Maintenance and repair 99/128
CytroBox, RE 51057-B/11.19, Bosch Rexroth AG
10.2 Inspection
BoschRexroth recommends documenting the inspection results so that
• considering functionality and economy, the inspection and maintenance intervals
can be adjusted to the actual operating conditions.
• by comparing the documented values, you can identify faults at an early point in
time.
 Before any inspection work, clean the hydraulic power unit as necessary.
 Carry out the following visual inspections for clearly apparent defects:
– Illegible notices or warning signs
– Leakage
– Loose and/or missing parts
 Indications of external force effects
10.3 Warning devices
The hydraulic power unit is equipped with an LED strip for status display:
• Normal operation: LED strip illuminated in cyan
• Warning: LED strip illuminated in yellow
• Error: LED strip illuminated in red
Precise reading of error messages is possible via the X26 interface
(engineeringport) of the control section and the IndraWorks DS software.
The errors are also indicated on the display of the drive controller, see Fig. 7,
pos.16 on page50.