The minimum pre-purging flow volume is based on a required to‐
tal tube length of 20 m.
Longer cables may require higher values. In this context, the de‐
tails on the purge gas connection and the pre-purging time of the
overall system must be observed.
UR/cUR listing
The motors were presented to the UL authorities “Underwriters Laboratories
Inc.®” and approved by UL according to UL1004 and CSA22.2., No. 100.
The appropriate identification is specified on the motor type plate.
Declaration of conformity
Declarations of conformity confirming the design and the compliance with ap‐
plicable EN standards and guidelines are available for the motors. A copy of
the declaration of conformity can be found in the “Appendix” chapter.
DOK-MOTOR*-IDYN*A*EXPD-IB05-EN-P Bosch Rexroth AG 27/69
Rexroth MAD and MAF Motors in EX px d Design acc. to ATEX Directive 2014/34/EU
Labeling the motors
To Next Page
Loading...
