RE 30232-02-B, Edition 02.2021, Bosch Rexroth AG
General information on damage to property anddamage to the product | Valve amplifier VT-MSPA2-2X 11/36
3 General information on
damage to property
anddamage to the product
NOTICE
High voltage!
The electronics may be damaged.
▶ Wire electronics from Bosch Rexroth only when these are disconnected from
the power supply.
Wrong cables! Power loss, scorching of cable!
Risk of damage to the product!
▶ Only use the cables specified in the data sheet with the respective cable
cross-sections for electronic devices from Bosch Rexroth!
Radiated interference!
Risk of malfunction.
▶ The distance to radio sources must be sufficiently large (>> 1 m).
▶ In the case of strongly fluctuating operating voltage, it may be necessary to
use an external smoothing capacitor in individual cases.
Emitted interference!
Risk of affecting other devices.
▶ Use shielded signal and solenoids cables in order that EMC requirements are
fulfilled.
Overloading!
Risk of overloading and damage to the supply cable in the case of insufficient
dimensioning and/or operation with several electrical devices.
▶ Provide current limitation by overload protection.
▶ Select an appropriate rating of power supply units and cables.
Short-circuit!
Risk of overloading and damage of the supply cable in the case of defects of the
electrical device.
▶ Provide current limitation by overload protection.
Impermissible temperature range!
Risk of overheating. The devices can be thermally destroyed.
▶ Adhere to the specification in the data sheet.
Cables lying around!
Risk of stumbling!
▶ Lay cables and lines so that they cannot be damaged and no one can trip over
them.
The warranty only applies to the delivered configuration.
The warranty becomes void if the product is incorrectly mounted, commissioned
or operated, not used as intended and/or handled improperly.
To Next Page
Loading...
