Bosch Rexroth VT-VSPA2-1-2X Series - Page 56

Hydraulics Bosch Rexroth AGRE 30110-Z/10.12 Additional information
3/10
Pre-settings
• VT-VSPA2-1-2X/V0/T1 serves as replacement for:
VT 3000, VT 3013, VT 3014, VT 3026,
VT- VSPA2-1-1X/T1, VT- VSPA2-50-1X/T1
• VT-VSPA2-1-2X/V0/T5 serves as replacement for:
VT 3006, VT 3017, VT 3018, VT-VSPA2-1-1X/T5,
VT-VSPA2-50-1X/T5
Re-wiring table
Terminal VT30... VT-VSPA2...1X
VT-VSPA2-1-2X/T1
Terminal
VT-VSPA2-1-2X/T5
Terminal
2a Output switch-over ±9 V Not available
1)
Not available
1)
2c – Ready for operation d22 d22
4a Call-up command value/ramp 2
d4 d4 and d12
4c Call-up switch-over ±9 V Not available
1)
Not available
1)
6a Call-up command value/ramp 3 d6 d6 and d14
6c Call-up command value/ramp 4
d8 d8 and d16
8a Input command value 3
b6 b6
8c Call-up command value/ramp 1 d2 d2 and d10
10a Input command value 2
b4 b4
10c Input command value 1
b2 b2
12a Input command value 4
b8 b8
12c Input command value 5 Not available
1)
Not available
1)
14a Ramp external d28 d28
14c Ramp external
d24 d24
16a Differential input
b14 b14
16c Differential input
b16 b16
18a Command value output
d30 d30
18c Call-up ramp off Not available
1)
Not available
1)
20a Measurement null b28 b28
20c +9 V output
b32 b32
22a Pin 1 solenoid B
z6 z6
24a Pin 1 solenoid A
z2 z2
26a 0 V input voltage
z32 z32
26c Output –9 V
b30 b30
28a Pin 2 solenoid B
z8 z8
28c Call-up voltage relay
z30 z30
30a Pin 2 solenoid A
z4 z4
30c – Release external
d18 d18
32a +U
B
Operating voltage z30 z30
32c +U
B
Operating voltage – d18 d18
Table 2: Re-wiring
1)
If the relevant function has previously been used, please refer to your sales contact partner.
The following pre-settings must be made before the exact ad-
justment of VT-VSPA2-1-2X/V0/T1 or T5:
• Exchange the card holder:
When replacing the amplifier card listed in the matrix by
the amplifier cards VT-VSPA2-1-2X/V0/T1 and T5, you
must moreover replace the existing card holder by the DIN
female multipoint VT 3002-1-2X/32D by a card holder with
the DIN female multipoint VT 3002-1-2X/48F.
• Carry out the re-wiring using the following table (differences
in the wiring are marked in gray):
The individual functions that are assigned to the relevant terminals are shown in the block diagrams on the following pages.