Bosch Rexroth WGM - 5.1.3 General Key Functions

Operation 15/46
RE51550-B/09.2019, BoschRexrothAG
5.1.3 General key functions
Operation is carried out via the keys below the display.
A detailed explanation of the menu control can be found in the following chapters.
Key Mode Function
u
Measured value display: Change of the displayed measurement.
In the menu: Change to a subordinate menu.
Change to the superior menu.
At the end of the menu:
The display indicates the end of the menu.
After input/selection: Confirm and save an entered numerical value or
a function selection.
If the parameter is changed, the display flashes.
p
Measured value display: Display of the configuration.
In the menu: Scroll menu item, numerical value or function
selection upwards. When holding down the key,
this is done continuously.
q
Measured value display: Change to the main menu.
In the menu: Scroll menu item, numerical value or function
selection downwards. When holding down the key,
this is done continuously.
q+ u
In the menu: Exit the main menu/submenu/optional menu and
return to the measured value display without
saving the changed parameters.
p+ u
In the menu: Change to the next higher menu level.
60s
no action
In the menu: Exit the main menu/submenu/optional menu.
Proceed as follows to select a menu item and set the values:
▶ Open the main menu with the q key.
▶ Select the submenu with the q and p keys and open the submenu with the u key.
▶ If necessary, select the next submenu with the q and p keys and open it with the
u key.
▶ Select the desired menu item with the q and p keys and open the value list with
the u key.
▶ Use theq andp keys to set the value and confirm with theu key. The changed
settings are saved and the device returns to the submenu.
▶ Exit the submenu by selecting the EXIT menu item and confirming with the u key.
The device returns to the superior menu or to the measured value display.