Change Time/Date
The time and date in your system must be correct for scheduled events to occur at the correct
times. Check the time at least once a month to ensure accuracy. Use this function to set both the
time and date. The system uses a 12-hour AM/PM format.
1. Ensure that your command center is at idle text.
2. Press the [COMMAND] bar. The display shows SYSTEM COMMAND.
3. Press the [4] key, followed by the [5] key.
Note: If you prefer, you may use the Command Menu in place of steps 2 and 3 to initiate this function.
Press the [MENU] key to enter the Command Menu, then press [NEXT] repeatedly until you
reach the CHG TIME/DATE ? prompt. Press [ENT].
4. The display shows ENT TIME. Enter the correct time and press [ENT].
5. AM ? displays.
• If you wish to choose AM, press [ENT].
• If you wish to choose PM, press [NEXT ]to display PM ?. Press [ENT].
6. The display shows ENT DATE. Enter the correct date and press [ENT].
7. The new time and date appear in the display.
8. To return to idle text, press [ESC].
45
To Next Page
Loading...
