Move to Area
With this function you can perform tasks in an area other than the one you’re in without having
to physically go to that area. Your access to other areas is limited by the scope of the command
center and your authority level. For example, if your passcode gives you authority to all 8 areas,
but the command center you’re working with is limited in scope to areas 1 and 2, then you will
only be able to move to either area 1 or area 2.
Upon moving to another area, the range of tasks you may perform depends upon the command
center you’re working with. Once you’ve performed a task (such as Turning the Area On), the
command center reverts back to its programmed area after 10 seconds. Thus only one task can be
performed in another area at a time.
1. Ensure that your command center is at idle text.
2. Press the [COMMAND] bar. The display shows SYSTEM COMMAND.
3. Press the [5] key, followed by the [0] key. The display shows ENTER AREA. Enter the
area number you wish to move to. Press [ENT].
4. AREA X MOVE displays briefly, and then the text of the area you’ve moved to is
displayed. You are now able to perform tasks in this area. The number of areas to which
you can move will be limited by the scope of the command center. If you try to move to
an area for which the command center does not have scope, NO AUTHORITY is
displayed.
5. When you have completed all tasks in the area you’ve moved to, simply allow the
command center to time-out and revert to the area from which you started or enter the
Move to Area function again.
To Next Page
Loading...
Need help?
General
