CHG PASSCODES ?
Description
Use this function to change your personal passcode without assistance from the security company.
Using Chg Passcodes
Before you begin:
• Choose a new passcode three to six digits long. If you choose a passcode with the same
digit in consecutive order (for example “33” in 334697), take care when entering it.
• To avoid conflicting with other passcodes and duress codes, your system does not let you
change to passcodes that are within plus or minus 2 of an existing passcode. For
example, if 1234 were an existing code, your system would not let you change your code
to 1232, 1233, 1235, or 1236.
1. Ensure your command center is at idle text.
2. Press the [COMMAND] bar. The display shows SYSTEM COMMAND.
3. Press the [5] key, then press the [5] key.
Note: If you prefer, you may use the Command Menu in place of steps 2 and 3 to initiate this function.
Press the [MENU] key to enter the Command Menu, then press [NEXT] repeatedly until you
reach the CHG PASSCODES ? prompt. Press [ENT].
4. The command center displays ENTER PASSCODE. Enter your current passcode.
Press [ENT].
5. ENTER NEW CODE displays. Enter your new passcode and press [ENT].
• If the passcode is already in use, your command center emits a buzz indicating that
the passcode is invalid. Choose another passcode.
6. ENTER NEW AGAIN is displayed. Enter your new passcode again.
7. Press [ENT] again. If you do not reenter the same new passcode, the display shows
NOT CHANGED and returns to idle text.
8. The command center briefly displays PASSCODE CHANGED and then returns to
idle disarmed text.
55
To Next Page
Loading...
Need help?
General
