7. VALID AREA1? displays. Press [YES] if you want the passcode to be valid in area 1.
Press [NEXT] if not.
• Enter the authority level for this passcode in area 1. You may assign an authority
level of 1 to 15. Press [ENT]. Press [NEXT] if you don’t want this passcode to have
authority in area 1.
• VALID AREA 2 ? displays. Press [YES] if you want the passcode to be valid in
area 2. Enter an authority level for this area and press [ENT]. Press [NEXT] if you
don’t want the passcode to have any authority in this area. Repeat this procedure
for areas 3 to 8.
8. The command center briefly displays PASSCODE ADDED and then returns to idle text.
To Next Page
Loading...
