Turn the Entire System On Without Delays
You can use this Command Menu function to turn on the entire system, both perimeter and
interior, without delays. You may use this function in all of the areas or some of the areas where
your passcode has authority. If there are areas already turned on, this function turns on all areas
that are off without changing the status of the areas that are already on.
1. Press the [ESC]/[MENU] keys to enter the Command Menu.
2. Press the [NEXT] key until the MASTER ARM INST ? function is displayed. Press
[ENT]. Your system may require a passcode before allowing you to access this function.
ENTER PASSCODE appears in the display. Enter your passcode and press [ENT].
3. The display shows ARM INSTANT ALL? Press [ENT]. The command center displays
the armed idle text for the area you are in. The actual number of areas you may turn on
is limited by command center scope and/or your authority level. For example, if you
have authority to arm all 8 areas but the scope of the command center you’re using is
limited to areas 1, 2, and 5, then you will only be able to turn on areas 1, 2, and 5.
4. To arm selected areas instantly, press [NEXT] at the MASTER ARM INST ? prompt.
Continue to press [NEXT] until you find the area you wish to arm. Press [ENT].
To Next Page
Loading...
Need help?
General
