Turning Off Selected Areas
• If your passcode has the proper authority level this function allows you to turn off areas other
than the one you are in.
1. With idle text displayed, press the [ESC]/[MENU] keys. Press [NEXT] until the DISARM
? function is displayed.
2. Press [ENT]. Your system may require a passcode before allowing you to access this
function. ENTER PASSCODE appears in the display. Enter your passcode and press
[ENT].
3. The display shows DISARM ALL? Press [NEXT].
4. The display shows DISARM AREA X ? If you want to disarm this area, press [ENT].
5. Pressing the [NEXT] key scrolls the remaining areas you have the authority to turn off
into the display. When the display shows an area you wish to turn off, press [ENT].
6. After turning off other areas, the command center’s display returns to the idle text for
the area you are in.
To Next Page
Loading...
