How to stop my Bosch Sensixx DS37 from steaming after I place it on the pad?
If your Bosch Iron does not stop steaming after placing it on the pad, it's because the steam release button has been activated for too long, that is, it has been pressed too frequently. Just press the trigger once again and the iron will stop steaming at once.
What to do if there's water leakage from the boiler of my Bosch Sensixx DS37?
If water leakage occurs from the boiler of your Bosch Iron, it is likely that the scale collector located at the bottom of the appliance is loose. Tighten up the scale collector to resolve this issue.
How to clean dirt coming out of the soleplate of my Bosch Iron?
If dirt comes out through the soleplate of your Bosch Iron, it indicates that the soleplate may be soiled. Clean the soleplate according to the cleaning instructions in this manual.
How to prevent water spots on garments when ironing with a Bosch Sensixx DS37?
If water spots appear on the garment during ironing with your Bosch Iron, it may be caused by steam condensed on the ironing board. To address this, wipe the textile cover of the ironing board and iron any water drops to dry them.
What to do if water flows through the holes on the soleplate of my Bosch Iron?
If water flows through the holes on the soleplate of your Bosch Iron, it's likely that the steam function is being used before the iron has reached the correct temperature. To resolve this, point the iron away from the ironing area and press the steam release button until steam is produced.
Why is my Bosch Sensixx DS37 not heating up?
If your Bosch Iron is not heating up, ensure that the main power button is in the “I” position (illuminated in red). Also, check that the temperature isn't set too low and adjust it to your desired level.
Why is my Bosch Sensixx DS37 not producing any steam?
If your Bosch Iron isn't producing steam, ensure the main power button is set to the “I” position (illuminated in red), and that the water tank is filled. Also, make sure the water tank is correctly fitted onto the housing until you hear a click, and increase the steam flow if the steam regulation is at its minimum.
Why is my Bosch Sensixx DS37 not producing steam?
To resolve the issue of your Bosch Iron not producing steam, consider the following: * Clean the boiler as described in section “Calc’n’Clean” if it contains too much scale, or there is a build up of scale or minerals in the steam tank. * Never add products to the water if chemical products or additives have been used. * Set the main power button to the “I” position and fill the water tank if the boiler is not switched on or the water tank is empty. * Fit the water tank back onto the housing correctly (you will hear a click) if the water tank is not fitted onto the housing correctly. * Increase the steam flow if the steam regulation is set to the minimum position.
Why is my Bosch Iron making a pumping sound?
Automatic temperature and steam setting for all fabric types.
Minimizes shiny marks on garments during ironing.
Guide for setting optimal temperature and steam levels.
Conserves energy and water during operation.
Enhances safety by automatically turning off the unit.
To Next Page
General