18
B O S C H
* Model dependent
Problem Possible causes Solution
The soleplate turns
brown.
1. This is a regular consequence
of continued use over a long
period of time.
1. Clean the soleplate with a damp
cloth.
The appliance makes
a pumping sound.
1. Water is being pumped into
the steam tank.
2. The water tank is not tted
onto the housing correctly.
3. The sound will not stop.
1. This is normal.
2. Fit the water tank back onto the
hou sing correctly.
3. If the sound will not stop, do not use
the steam generator and contact an
authorised technical service centre.
Loss of pressure
during ironing.
1. Steam release button has
been activated for too long a
period of time, that is, it has
been pressed too frequently.
1. Use the steam release button at
intervals. This improves the ironing
result as the textiles will be steamed,
dried and ironed properly.
Water spots appear on
the garment during
ironing.
1. May be caused by steam
condensed on the ironing
board.
1. Wipe the textile cover of the ironing
board, and iron any water drops to
dry them.
Water spots appear on
the garment during
use of the
“PulseSteam” function.
1. Water spots are caused by
steam condensation in the
hose when cooling down after
use.
1. Water drops stop coming out of the
soleplate after using the
“PulseSteam” function for some
time.
The hose gets hot
during use.
1. This is normal. It is caused by
the steam passing through the
hose during steam ironing.
1. Place the hose on the opposite side
so that you cannot touch the hose
during ironing.
Water leakage from
the boiler.
1. Scale collector
(12) located at
the bottom of the appliance is
loose.
Tighten up the scale collector.
The iron does not stop
steaming after placing
it on the pad (2).
1. “PulseSteam” function has
been activated.
1. Just press the trigger once again
and the iron will stop steaming at
once.
If the above does not solve the problem, get in touch with our customer service.
To Next Page
Loading...
