7
B O S C H
* Model dependent
Description
1. Water tank
2. Removable iron pad
3. Iron lock system “SecureLock”
4. “Calc” automatic clean warning indicator
light
5. “Water tank empty” indicator light
6. Energy saving “eco” button and indicator
light (green)
7. Ironing programme indicator lights
8. “Calc’nClean” decalcication programme
and indicator light
9. Programme selector and illuminated ring.
10. “on-off” power button.
11. Steam hose
12. “Calc’nClean Perfect” scale collector
13. Mains cable with storage facility
14. Steam release button
15. Steam shot button “PulseSteam”*
16. Iron pilot light
17. Soleplate
18. Fabric-protection soleplate cover*
1. Preparations
1. Release the iron from its lock system (3)
by pulling the lever located at the heel of
the iron backwards.
2. Remove any label or protective covering
from the soleplate.
3. Place the appliance horizontally on a
solid, stable surface. You may remove
the iron pad from the appliance and place
the iron on it on another solid, stable,
horizontal surface.
4. Fill the water tank, making sure not to
pass the “max” level mark.
5. Unwind the mains cable (13) fully and
plug it into an earthed socket.
6. Set the power button (10) to the on
position.
7. The appliance will shift automatically to
the “i-Temp Advanced” programme (see
section 3.1). The corresponding indicator
light (7) will ash, and after a few minutes,
will remain lit continuously. Two beeps will
be heard indicating that the appliance is
ready to use.
The steam generator will take more time
to reach this state only upon the initial
heating up, or after performing the de-
scaling operation (Calc’nClean).
When water is already present in the
steam generator during regular use,
heat up time to reach the operating
temperature will be faster.
To Next Page
Loading...
