Setting up and connectingde
4.4 Drinking water connection
2.Plug the power plug of the device's
power cord into a socket near the
device.
Connect your device to a drinking
water connection.
Install drinking water connection
The connection data of the
device is on the nameplate.
Hints
¡Make sure you do that
Connect the device to a water inlet
with a safety device to prevent
drinking water contamination
through backflow (according to DIN
EN 1717). The connection valves/
water taps provided for this purpose
are equipped with this safety device
if the house is installed correctly.
¡If you replace the device,
you must use a new water inlet
hose.
3.Check that the power plug is firmly
seated.
1.Please refer to the assembly
instructions provided for the
necessary steps.
2.Connect the device to the drinking
water connection using the
included parts.
Observe the technical data.
3.Make sure that the drinking water
connection is not kinked, crushed or
twisted.
4.5 Electrical connection
Connect the device electrically
Hints
¡Observe the safety instructions
wise →
page 4
.
¡Please note that the water
Safety system only works when
there is power supply.
1.Insert the cold appliance plug of the
mains connection cable into the
device.
13
To Next Page
Loading...
