Bosch SMU4ECS10E - Setting the Amount of Rinse Aid Added; Switching off the Rinse Aid System

Rinse aid systemde
2.Fill in the rinse aid up to the max
mark.
– A higher level adds more rinse
aid to the rinse cycle, reduces
water stains and produces a
better drying result.
5.To save the settings,
Press for 3 seconds.
Max
11.3 Switch off the rinse aid
system
If the rinse aid refill indicator bothers
you, for example if you use combined
detergents with a rinse aid
component, you can switch off the
rinse aid system.
3.If rinse aid has overflowed, remove
it from the rinse tank.
Tip:The function of the rinse aid is
limited with combined detergents. If
you use rinse aid, you usually achieve
better results.
Overflowing rinse aid can lead to
excessive foam formation during
the rinse cycle.
4.Close the lid of the rinse aid
reservoir.
1. press.
aThe lid clicks into place with an audible click.
2.To open the basic settings,
3 seconds
press.
11.2 Setting the amount of rinse
aid added
aThe display shows Hxx. a
The display shows
If streaks or water stains remain on
the dishes, change the amount of rinse
aid.
1. press.
.
3. Press repeatedly until
the display shows the factory-set
value r05.
2.To open the basic settings,
3 seconds
press.
4. Press repeatedly until the
display shows r00.
5.To save the settings,
Press for 3 seconds.
aThe display shows Hxx. a
The display shows .
aThe rinse aid system is switched off
switches on and the rinse aid refill
indicator is deactivated.
3. Press repeatedly until
the display shows the factory-set
value r05.
4. Press repeatedly until the
appropriate amount of rinse aid
has been added.
– A low stu rinse
cycle
and reduces Sc
Dishes.
fe gives that
he rinse aid too
hlieren on the
29