Troubleshootingde
Disturbance Cause and troubleshooting
Removable streaks
are located on glasses,
glasses with a metallic
appearance
and cutlery.
The dishes are blocking the detergent lid.
2.Do not place dishes or air fresheners in the tab drip
tray.
Dishes have been pre-cleaned too much. The sensors
decide on a weak program flow. Stubborn dirt
sometimes cannot be removed.
▶ Only remove large food residues and do not pre-
wash the dishes.
Traces of rust on surfaces
plug.
Cutlery is not sufficiently rust-resistant. Knife blades
are often more severely affected.
▶ Use rust-resistant dishes.
Cutlery also rusts if rusting parts are washed with it.
▶ Do not wash rusty parts.
Salt content in the rinse water is too high.
1.Remove any spilled special salt from the rinsing
container.
2.Tighten the cap of the special salt container tightly.
There are cleaning residues
in the detergent
chamber or in the
tab collecting tray.
Spray arms were blocked by crockery and the
detergent was not rinsed out.
▶ Make sure the spray arms are not blocked and
can rotate freely.
The detergent chamber was damp when the detergent was
filled.
▶ Only pour cleaner into a dry cleaner chamber.
Refill indicator for
Special salt lights up.
Special salt is missing.
▶
Fill with special salt →
Page 27
a.
Sensor does not recognize special salt tablets.
▶ Do not use special salt tablets.
51
To Next Page
Loading...
