Set up and connectNL
a continuous worktop that is
permanently connected to the adjacent
cabinets.
1.Observe the safety instructions. →
Page 4
4.4 Drinking water connection
Connect the device to a drinking
water connection.
Install drinking water connection
2.Observe the instructions for the
electrical connection.
Remark
¡If you replace the device
use a new water supply hose.
3.Check the contents of the package
and the condition of the device.
4.The required installation dimensions can be found
in the installation instructions.
1.You will find the necessary steps in
the supplied installation manual.
5.Level the appliance using the
adjustable feet.
2.Connect the device to the drinking
water connection using the
enclosed parts.
Pay attention to a firm stand.
6.Install the drain water connection.
→
Page 13
Observe the technical data.
7.Install the drinking water
connection. →
Page 13
3.Make sure that the drinking water
connection is not kinked, crushed
or entangled.
8.Connect the device to the
power.
4.5 Electrical connection
4.3 Drain water connection
Connect the device electrically
Connect the appliance to a drain
water connection so that the dirty
washing water can be drained away.
Comments
¡Take the safety rules
→
Page 4
in mind.
¡Please note that the
protection system only works when
the device is supplied with power.
Install waste water connection
1.You will find the necessary steps in
the supplied installation manual.
1.Connect the appliance plug of the
connection cable to the
appliance.
2.Connect the drain hose to the
connection nipple of the siphon
using the parts supplied.
2.Insert the mains plug of the
appliance's connecting cable into
a socket in the vicinity of the
appliance.
3.Make sure that the drain hose is not
kinked, crushed or tangled.
4.Make sure that the water is not
prevented from flowing out by a
plug in the waste water connection.
The connection data of the device
can be found on the rating plate.
3.Check the mains plug for tightness.
13
To Next Page
Loading...
