Bosch SMV6YCX00E - Switching off Water; Softening

Softening systemNL
1.Unscrew and remove the lid of the
softener salt reservoir.
salt component, you can switch off
the softening salt indicator.
2.When using for the first time: fill the
tank completely with water.
Remark
To prevent damage to the
appliance, only switch off the
water softener in the following
cases:
¡The water hardness is max.
times 21 °dH and you use a
combined detergent with salt
substitutes. Combined detergents
with salt substitutes can only be
used according to the
manufacturer's instructions up to a
hardness level of 21 °dH without
adding softening salt.
¡The water hardness is 0 - 6
°dH. You do not need to use water
softener salt.
3. Note:Only use softening salt for
dishwashers.
Do not use salt tablets. Do not
use table salt.
Put the softening salt in the
softening salt tank.
1.Press.
Completely fill the softening salt
reservoir with softening salt. The
water in the reservoir is displaced
and flows away.
2.Approx. up for 3 seconds
to access basic settings.
Busy-
aThe display shows Hxx. a
appears on the display
to give.
3.Just as often
the display shows H00.
4.To save the settings, press for
approx. 3 seconds to press.
aThe water softener is switched off
switched on and the salt refill
indicator is deactivated.
4.Fit the reservoir lid and screw it
shut.
displayed
press until
10.4 Switch off water
softening
If the refill water softener indication
bothers you, for example if you use a
combined detergent with
25