Bosch SOLUTION 3000 User Manual

Control Panel Operation with ICON LCD Codepad | en 15
Bosch Security Systems, Inc. User's Guide 2017.09 | 04 | F.01U.298.028
How to arm Area 1 or Area 2 in STAY Mode 1
Enter your user code followed by [0][1] and the [*] button ( for example, [258001*]) to arm
Area 1; or enter your user code followed by [0][2] and the [*] button ( for example,
[258002*]) to arm Area 2. Two beeps sound and the STAY indicator displays. Exit Time starts
counting.
How to disarm Area 1 or Area 2 in STAY Mode 1
Enter your user code followed by [0][1] and the [*] button ( for example, [258001*]) to
disarm Area 1; or enter your user code followed by [0][2] and the [*] button ( for example,
[258002*]) to disarm Area 2. Two beeps sound and the STAY indicator extinguishes.
5.4 User Codes
5.4.1 Adding User/Radio Codes
Only the Master Code holder can add or change other system user codes, including the Master
Code. Up to 32 user codes / radio user codes can be programmed to operate the system.
How to Add a User Code
1. Enter your Master Code, followed by [1] and the [#] button (for example, [25801#]).
Three beeps are heard and the STAY and AWAY indicators flash.
2. Enter the User Code number (1 to 32), followed by the [#] button (for example, [2#] =
User 2, [8#] = User 8). Two beeps are heard and the selected user number displays on
the codepad indicators.
3. Enter the digits required for the new code followed by the [#] button (for example, for
User Code 5768, enter [5768#]). Two beeps are heard and the STAY and AWAY indicators
turn off.
To add or change other User Codes, repeat this procedure as many times as required.
How to Add a Radio Code (WE800EV2 Keyfob)
Notice!
Learn all WE800EV2 keyfobs via WE800EV2 receiver Learn/Delete button before adding the
WE800EV2 keyfobs to the system. Refer WE800EV2 manual for learn/delete fobs.
Set RF receiver as WE800EV2 Receiver.
1. Enter your Master Code, followed by [1] and the [#] button (for example, [25801#]).
2. Enter the WE800EV2 keyfob number (301 to 332) you want to add, followed by the [#]
button. Up to 21 WE800EV2 keyfobs can be added, but only current keyfob number (1 to
16 ) displays through zone indicators on the ICON codepad.
3. Only use auto-learn mode to configure keyfob RFID. Press [#] button to switch into auto-
learn mode. When icon numbers (1 to 16) flash, press button 1 or 2 of the keyfob. The
panel learns the WE800EV2 Keyfob ID number and the last digit of RFID number displays
on the codepad. Press [#] button to confirm.
4. Enter [#] button to confirm the operation, or press [*] to cancel.
How to Add a Radio Code (RADION Keyfob)
Notice!
Solution 2000 does not support RADION keyfobs.
Set RF receiver as RADION Receiver.
1. Enter your Master Code, followed by [1] and the [#] button (for example, [25801#]).

Bosch SOLUTION 3000 Specifications

General

Brand	Bosch
Model	SOLUTION 3000
Category	Control Panel
Language	English