Control Panel Glossary of Terms | en 27
Bosch Security Systems, Inc. User's Guide 2017.09 | 04 | F.01U.298.028
Term Description
hand-held radio
remote control
A device used to arm and disarm a security system or to cause a panic
alarm.
isolate A method of manually disabling (isolating) one or more zones before
arming the system.
master code A numeric code used for allowing those users that have the appropriate
priority level to perform certain supervisory level functions.
monitoring station A secure location where a digital receiver monitors a number of alarm
systems and deciphers their alarm transmission reports so the operator
can advise the appropriate authorities to take immediate action.
panic A condition or type of alarm in which the user requires either immediate
police or medical assistance.
sealed Refers to a zone’s status. If a zone is sealed, the detection devices are
not violated and the zone indicator is not lit (that is, a reed switch is
closed or a detector is on standby waiting for an intrusion).
sensor watch A feature that allows the control panel to recognize when detection
devices might have stopped working. Sensor watch monitors the
operation of a zone over a programmed time period.
silent alarm An alarm that sounds only at a remote location, and gives no obvious
local indication that an alarm was sent out.
STAY Mode 1 A condition that automatically isolates certain zones when the security
system is armed in this mode. Only the installer can program these
zones.
STAY Mode 2 A condition that automatically isolates certain zones when the security
system is armed in this mode. The Master Code holder can program
these zones.
telco arming
sequence
A feature that automatically diverts a telephone number to another
telephone when a security system is armed in AWAY Mode, the same as
using call forwarding.
telco disarming
sequence
An automatic suspension of diverting of the telephone when the system
is disarmed.
unsealed Refers to a zone’s status. If a zone is unsealed, the detection devices
are violated and the zone indicator is lit (that is, a reed switch is open
or a detector noted an intrusion).
user code A numeric code used to arm and disarm the system.
zone A monitored input used to activate an alarm. A zone might be set up to
activate an alarm only when the system is armed or to operate whether
the system is armed or disarmed.
Tab.6.11: Glossary of Terms
To Next Page
Loading...
Need help?
General
