3BB7<5B=<=E-=C@+3B(7:3'B=<3'/E
#"#'E7B16 – Energizes the unit.
:/23C/@2 – The blade guard is a safety de-
vice. It can be opened or closed by turning the
knob on the blade guard. Make sure that the
blade guard is locked before cutting.
:/23C/@2 =19<=0 – Twist to lock and
unlock blade guard door for changing blades.
'>7<2:3 =19 – Press the spindle lock to keep
the shaft from rotating while changing the saw
blade.
:/23 – Use 10" (254 mm), 8” (203 mm)
)<7D3@A/:C723 – Quick set up for 0°, 22.5°
and 45° cuts.
(/0:3 =19 – Locks sliding work table in two
positions for storage or under the blade for
plunge cutting below the blade.
':727<5+=@9(/0:3 – The work platform can
be moved along the rails.
FB3<A7=<+=@9(/0:3 – Attaches to the work
table to support large workpieces.
':727<5+=@9(/0:3'B=> – Provides hard stop
for sliding work table.
&/7:A – The sliding work table moves along the
two rails when cutting a workpiece.
@/;3 – The base of the wet tile saw.
+/B3@(@/G – Holds the water needed to cool
the blade and features drain plug to empty.
<B7'>:/A6C/@2 – Minimizes the over-spray
and mist when cutting.
+@3<16'B=@/53:7>A – Conveniently holds
the nut wrench and hex wrench when they are
not in use.
&3/@FB3<A7=<+/B3@(@/G – Catches over-
spray from large tile and redirects water into the
tray.
'7
23
F
B3
<A
7=
<
+
/B
3@
(
@/
G
'
GA
B3
;
– Catcheswater dripping from sides of tile and redirects
water into the tray.
'C>>=@B@; – Supports the motor unit on the
frame.
-8-
To Next Page
