6 en | VG4 Firmware Updates via a TCP/IP Network AutoDome Modular Camera System
F01U096914 | 1.05 | 2008.10 Firmware Update Manual Bosch Security Systems, Inc.
Note: Subcomponent files in dialogue box may differ depending on the model of
AutoDome and firmware being uploaded.
A highlighted filename indicates that the service pack directory contains that file.
However, Boot files are stored in a separate Boot directory. If you are not in the Boot
directory, the dialogue box will not highlight the boot files even though they are included
in the service pack.
In the parenthesis to the right of a filename, the dialog box displays the version of the file
currently installed in an AutoDome and the version contained in the service pack
separated by one of the following symbols:
4. Click OK to the warning message to continue the firmware upload, or Cancel to stop the
upload.
Figure 1.7 Warning message
Symbol Description
= The file currently installed is the same version as the file in the service pack
< The file currently installed is an earlier version than the file in the service pack.
The Update process automatically selects this file.
> The file currently installed is a later version than the file in the service pack. If
you choose to install this file, you receive a warning that the installation of this
file may cause system instability.
CAUTION! Updating the firmware erases all device settings. To save these settings, click the
Configuration download button to save the current device settings and then upload this file
after the completion of the firmware update.
To Next Page
Loading...
Need help?
General
