AUTODOME Bubble Replacement
This guide provides instructions for replacing a bubble on an
AUTODOME camera (of VG4 Series, VG5 Series, or 7000 Series)
with in-ceiling or pendant housing. The guide also includes
important information about handling and cleaning the bubble.
Replacement bubbles are made of either Polycarbonate or
Acrylic. Rugged polycarbonate bubbles provide high impact
resistance, and are comparable to glass or acrylic, although their
surface is much softer. High-resolution acrylic bubbles offer
enhanced image clarity for high-resolution images but are low-
impact.
Warning!
High-resolution acrylic bubbles are not permitted to be used
with a VG4 Pressurized Environmental Housing. If not avoided,
this application could result in bodily injury and damage to the
camera.
Warning!
Polycarbonate bubbles are not recommended for use in HD
AUTODOMES, due to optical quality degradation.
Unpacking
This equipment should be unpacked and handled with care. If an
item appears to have been damaged in shipment, notify the
shipper immediately.
Verify that all the parts listed in the Parts List below are
included. If any items are missing, notify your Bosch Security
Systems Sales or Customer Service Representative.
The original packing carton is the safest container in which to
transport the unit and must be used if returning the unit for
service. Save it for possible future use.
1
1.1
4 en | AUTODOME Bubble Replacement
AUTODOME Bubble
Replacement (VG4, VG5,
or 7000 Series)
2013.06 | 2.1 | F.01U.288.194 Bosch Security Systems, Inc.
To Next Page
Loading...
