IP Matrix operation with KBD-UXF Operation | en 9
Bosch Security Systems B.V.
Operation manual
2023-03 | V02 | DOC
Switches between live mode and playback mode.
Blinking indicates that the function is enabled.
4 Press the key to switch.
Note: Only supported by firmware9.60 and later. Playback permission must be available.
Loads a camera sequence
4 Press the key, enter a valid sequence number (1 to 32), then click OK.
Note: Blinking indicates that the input of a number is required.
Switches to previous layout with less monitors
4 Press the key to decrease
the number of monitors on the current display.
Note: This key provides a round-trip function. The last layout starts again, if the first layout is
reached.
Switches to next layout with more monitors
4 Press the key to increase the number of monitors on the current display.
Note: This key provides a round-trip function. The first layout starts again, if the last layout is
reached.
Turns full-screen of currently selected monitor on/off
4 Press the key to turn full-screen on or off.
Turns full-screen with picture-in-picture on/off
4 Press the key to turn full-screen with picture-in-picture on or off.
1 …. 0 Number keys
4 Use to select favorite views, sequences, prepositions, or single devices.
ESC Cancels a number entry.
4 Press the key to cancel the entering of a number.
OK Confirms a number entry.
4 Press the key to confirm.
Selects or saves a preposition
To select a preposition:
4 Press the key, enter the preposition number using the number keys, then click OK.
To Next Page
Loading...
