VOT-320 Configuration using a Web browser | en 31
Bosch Sicherheitssysteme GmbH Installation and Operating Manual DOC | V4.5 | 2010.09
5.6 Basic Mode: Encoder
Non-recording profile
You can select a profile for encoding the video signal.
You can use this to adapt the video data transmission to the operating environment (for
example network structure, bandwidth, data load).
Pre-programmed profiles are available, each giving priority to different perspectives. When
selecting a profile, details are displayed in the list field. Below is a brief description of the
factory default settings for the encoder profiles.
– High quality 1
For high bandwidth connections with IBBP GOP structure
– High quality 2
For high bandwidth connections with IP GOP structure
– Low bandwidth
For low bandwidth connections with lP GOP structure
– DSL
For DSL connections with 500 kbps
– ISDN (2B)
For ISDN connections via two B-channels
– ISDN (1B)
For ISDN connections via one B-channel
– MODEM
For analog modem connections with 20 kbps
– GSM
For GSM connections at 9,600 baud
NOTICE!
The names and the technical details for the encoder profiles depend on the configuration of
the device.
To Next Page
