en Installing and connecting the appliance
18
Before using the appliance for
the first time
Before you switch on the appliance:
Check that there is no visible damage to
the appliance. Do not operate the
appliance if it is damaged. Should you
have any problems, please contact your
specialist dealer or our customer
service.
Your appliance has been thoroughly
tested before leaving the factory. To
remove any water that may be left over
from testing, run the first wash cycle
without any laundry.
Run a programme without laundry as
follows:
1. Turn the programme selector to
switch on the appliance.
2. Close the door.
3. Set the Baumwolle (Cottons) 90 °C
programme.
4. Pull out the detergent drawer.
5. Pour approximately 1 litre of water
into the left-hand compartment.
6. Pour standard washing powder into
the left-hand compartment.
Note: Prevent foaming by only using
half of the amount of detergent
recommended by the detergent
manufacturer. Do not use detergents
intended for woollens or delicates.
7. Push in the detergent drawer.
8. Press Start/Nachlegen
(Start/Pause).
9. At the end of the programme, switch
off the appliance or start the first
wash cycle.
To Next Page
Loading...
