Bosch WAN280H1 - Programme End; Removing Laundry and Switching off the Appliance; Appliance Settings; Childproof Lock

Appliance settings en
35
Programme end
“Ÿš will appear on the display.
Removing laundry and
switching off the appliance
1. Remove the laundry.
2. Turn the programme selector to
switch off the appliance.
Notes
■ Risk of rusting: Remove any foreign
objects from the drum and the
rubber seal.
■ Wipe the rubber seal dry.
■ Leave the door and detergent
drawer open so that residual water
can evaporate. ~ Page 37
2 Appliance settings
Appliance settings You can activate/deactivate the
childproof lock and adjust the basic
settings (e.g. signals).
Childproof lock
Activating the childproof lock prevents
the settings from being accidentally
changed on the control panel.
Activate/deactivate the childproof lock
as follows:
Press and hold U/min (rpm) and Fertig
in (Ready in) at the same time for
approximately 3 seconds.
Note: The childproof lock will remain
active even after the appliance has
been switched off. In order to operate
the control panel when you turn on the
appliance, you will need to deactivate
the childproof lock.
Basic settings
You can adjust certain basic settings on
the appliance. To make adjustments,
you will first need to Call up the setting
mode:
1. Set the programme to the (
position.
2. Press Start/Nachlegen (Start/
Pause) and set the 0 programme
at the same time.


#
+
3
;