NL Troubleshooting
Malfunction
"E:30/-20"
Cause and Troubleshooting
Solenoid valve defective.
▶
Please contact customer service.
→
"Customer Service", page 56
Detergent dosage is too high.
▶
When dosing manually, reduce the amount of
detergent for the next wash with an equal load.
Additional water filled.
▶
Do not fill the device with additional water during
operation.
Device not working. Mains plug of the power cable is not plugged in.
▶
Connect the appliance to the mains.
Fuse is defective.
▶
Check the fuse in the meter box.
Power supply has failed.
▶
Check whether the interior lighting or other
appliances are working.
Program does not start. Start/Refill was not pressed.
▶
Press Start/Refill .
Door is not closed.
1. Close the door.
2. To start the program, press Start/Refill
.
Child lock is activated.
▶
→
"Deactivate child lock", page 34
- Ready in + is activated.
▶
Check if - Ready in + is activated.
→
"Buttons", Page 25
Laundry is wedged in the door.
1. Open the door again.
2. Remove trapped laundry.
3. Close the door.
4. To start the program, press Start/Refill
.
The detergent drawer is not closed as far as it will go.
▶
Push the detergent drawer into the appliance as far as it
will go.
Pump of the intelligent dosing system is blocked.
46
To Next Page
Loading...
