TroubleshootingNL
Malfunction Cause and Troubleshooting
At the water supply
feed hose is leaking water.
The water inlet hose is not correctly / firmly
connected.
1.Connect the water supply hose correctly.
→
"Connecting the water inlet hose", page 15
2.Tighten the coupling properly.
Water is leaking from
the water drain hose.
Water drain hose is damaged.
▶ Replace the damaged water drain hose.
Water drain hose is not connected correctly.
▶ Connect the water drain hose correctly.
→
"Drainage connection types", page 15
Lint on the laundry. In the drum his fluff has collected.
▶ Run the program Cleaning the drum Sun-
of laundry and detergent.
Water entry noise during
during the drying phase.
Drying phase needs water.
1.No malfunction.
2.Make sure that the water tap remains open
during the drying phase.
Drying program
do not start.
Door is not closed.
1.Close the door.
2.To start the program, press .
No drying program selected.
▶ Select a suitable drying program.
→
"Programs", Page 27
Laundry is too damp. Inappropriate program set for the type of fabric.
Power supply has failed.
▶ Check whether the interior lighting or other
appliances are working.
The load quantity is too high.
Warm laundry feels damper than it actually is after
the program has ended.
1.Remove the laundry from the drum immediately after
drying.
2.Spread the items out to let them cool.
Inappropriate drying target set.
Drying target not adjusted.
Loading quantity too little.
Humidity sensor contaminated.
Water tap closed during the drying phase.
51
To Next Page
Loading...
