NLTroubleshooting
Malfunction Cause and Troubleshooting
Laundry is too damp. ▶ Make sure that the water tap remains open
during the drying phase.
Ambient temperature is higher than 30°C.
▶ Make sure the ambient temperature is below 30°C.
Insufficient air circulation at the location of the
device.
▶ Ventilate the installation site of the device.
Water pressure is low.
No solution possible.
Laundry insufficiently spun.
▶ Always select the maximum possible spin speed for
the respective wash programme.
Thick and multi-layered textiles require a longer drying
time.
▶ Set a time program for post-drying.
→
"Programs", Page 27
Fan noise during the
washing phase.
Process fan active.
▶ No error - normal operating noise.
The program duration
changes during the wash
cycle.
The program sequence is electronically optimized. This
may lead to changes in the program duration.
▶ No error - no action required.
The imbalance control system eliminates the
imbalance by distributing the laundry several times.
▶ No error - no action required.
Remark:When loading, place large and small items of
laundry together in the drum. Different sized laundry
is more evenly distributed during the spin cycle.
Foam control system provides an extra rinse when
foaming is too high.
▶ No error - no action required.
Drum jerks after
program start.
The cause is an internal motor test.
▶ No error - no action required.
fizzing, hissing
loud.
Water is flushed into the detergent drawer under
pressure.
▶ No error - normal operating noise.
52
To Next Page
Loading...
