NLSet up and connect
If the device is tilted more than 40°,
residual water can run out of the
device and cause material damage.
▶ Carefully tilt the device.
▶ Transport the device upright.
4.4 Removing transport locks
The device is secured for transport
with transport locks at the rear of the
device.
installation site
Plinth
To demand
Remark:Keep the screws of the
transport locks and the sleeves for
later transport
→
Page 56
.
The device with
locking lips
→
Page 31
to confirm.
1.Pull the hoses out of the holders.
Floor with wooden
beams
Place the device
guess at a wa-
resistant
wooden plate (thick-
too minimal
30mm) which
screwed to the
floor.
kitchen The device al-
borrow under a
continuous work
place sheet,
that fixed with the
adjacent
cabinet is connected
Pine tree. Required
niche width:
60 cm.
2.Loosen and remove all bolts of the 4
transport locks with a SW13 open-
end wrench
.
on a wall No snakes and
mains connection
between wall and
device clamping
man.
14
To Next Page
Loading...
